Industry News

Home / News / Industry News / How to maintain the paste filling machine

How to maintain the paste filling machine

19-Feb-2022

Since the paste filling machines for filling are generally those paste-like viscous liquids, it is more troublesome to remove the residual substances. Therefore, the cleaning and maintenance of the paste filling machine filling machine has become a special one.
Cleaning paste filling machine filling products must be thoroughly cleaned. Dirt or grease cleaners can be wiped off with a soft woven cloth, then dry with a soft and non-woven cloth. Check whether the contact part between the paste filling machine and the material is clean and whether it meets the corresponding requirements. If it does not meet the requirements, it needs to be cleaned and dried again.

Below, we summarize the experience of the maintenance of the quick paste filling machine:
1. Regularly check the pneumatic triple parts of the wet air filter and the lubricator (if the amount of oil is insufficient, it cannot be refueled in time; if there is too much water, it should be removed immediately).
2. During the production process, always check the rotation and landing of mechanical parts to see if there is any abnormal situation, and do not loosen the screws.
3. Regularly check the reliability requirements of the ground contact paste filling machine, whether the pneumatic pipe is leaking, whether the air pipe is broken, and always clean the weighing platform.
4. Replace the lubricating oil (grease) of the motor reducer every year, check the tension of the chain, and adjust the tension.
5. Paste the filling machine cylinder with good lubrication at the factory, do not remove or add any cylinder.
Continuous operation for 6 hours does not exceed 10 hours. In order to ensure the normal cleaning and cooling of the water pump, do not cause the water pump to be short of water in the spindle motor, and replace the cooling water regularly to prevent the water temperature from being too high. The temperature in winter is too low, if the working environment can put antifreeze in the water tank.